Download here: https://drive.google.com/file/d/1QeMCUM6TcvXGGPdXHz68Jst2bKcByxr7/view


Smart Access Reader Installation Guide

Applicable Parts: LBA-ACR-M1-B &  LBA-ACR-SG-B

In order to make sure that LittleBird technology offers a valuable experience for all customers and users, all hardware associated with LittleBird features must be installed carefully and accurately. This document outlines the installation steps required to properly install the access card readers that are most compatible with LittleBird’s smart access features. 

The installation instructions covered in this document can be applied to each of the following product models: 

  • LBA-ACR-M1-B

  • LBA-ACR-SG-B

For questions or additional instructions, please contact LittleBird support at 1-602-607-4620 or visit partner-support.golittlebird.com.


Mounting

  1. Remove the backplate from the reader by removing the security screw at the bottom.

  2. Drill two holes in the wall for the screws at the bottom (C) and top (A) of the backplate and one in the middle (B) for the wiring. Holes ‘A’ and ‘C’ can be used to attach the backplate to a standard backbox.

  3. Knock the wall fixing plugs off the top (A) and bottom (C) holes in the backplate.

  4. Screw the back cover to the wall.

  5. Attach the unit to the back cover and secure it with the security screw on the bottom.


Wiring

Color

Function

Notes

Red

Power +

9~18V DC Power Input

Black

GND

Ground

Green

D0

Wiegand D0

White

D1

Wiegand D1

Brown

LED

Green LED light control

Yellow

Buzzer

Buzzer Control



Connecting to a DMP 734 Module

Connect card reader Red, Black, Green, and White to access module Wiegand input screw terminals. The use of 22/6 multi-conductor wire for the card reader is recommended in the wiring process. 

Do not cross the Wiegand (green and white) wires with the Power + (red) or you can damage the reader.

Note: Card reader White will be used in place of the access module Yellow terminal.